My Gas Burner for Ooni 3 has an uneven flame.

Before following the steps below, please read the following safety advice:

• Always stand clear of your oven when igniting - ensure nobody is within 1 meter (3ft) of the front of the oven.
• Always allow 5-minute intervals between lighting attempts. This is to allow time for any gas to disperse.
• Read through the safety manual for your region:
  • United States and Canada
  • Europe 30mBar
  • UK and Europe 37mBar
  • Europe 50mbar

If you have an uneven flame in your oven, follow the steps below:

1. Remove blockages from the burner surface
   • Ensure the oven and gas burner have cooled down
   • Remove the gas burner and take a can of compressed air and give the burner a good blast around the area the flames come out
   • Once you've given it a good blast, insert the gas burner back into the oven, and run the gas burner for 30 minutes
   • We recommend doing this every so often as part of a normal cleaning/service
     
     
2. Remove blockages from inside the burner
   • Ensure the oven and gas burner have cooled down
   • Remove the gas hose from the burner
   • Push in the gas control dial and blast compressed air through the stem where the hose attaches to the burner
   • Reconnect the gas hose and run the oven for 30 minutes
     
3. Change the gas bottle
   • A new gas bottle can make all the difference, especially if the one you're using is less than half full
     
     
4. Swap out the gas regulator
   • If you have a spare regulator on hand, try swapping it over